Forum Navigation
Post History: getbent
So i tapped the blue wire on the positive battery post and the RPM jumped up to 175 then back to 0 w …In: stumbling and die
7 years ago
everything on the handheld is showing a value just not the RPM. the voltage on the handheld is showi …In: stumbling and die
7 years ago
Has anyone every had an issue where the fitech unit will not pick up the Tach signal but the tach on …In: stumbling and die
7 years ago
So over the weekend i got a new handheld from FItech when i was thinking they where only sending out …In: stumbling and die
7 years ago
anyone have any idea what the standard shipping time frame is on getting something from Fitech? it h …In: stumbling and die
7 years ago
so I went out to drive the truck and it would not read the tach signal but the on dash tach was read …In: stumbling and die
7 years ago
/well I am gonna take it for a drive and see what it does. I am hoping everything stays good. The on …In: stumbling and die
7 years ago
So i got the Fitech put back on the truck, went to start it up yesterday and the system would not re …In: stumbling and die
7 years ago
It will be a little while before I get the fitech put back on the truck. I have some car shows comin …In: stumbling and die
7 years ago
I have checked for exhaust leaks time and time again. nothing. what on the data log shows that the o …In: stumbling and die
7 years ago
https://www.dropbox.com/s/oajury03xspinvf/DashBoard5.csv?dl=0
so this is what the truck did tonig …In: stumbling and die
7 years ago
The weather is looking a little better today. I am going to get the truck running tonight and do a d …In: stumbling and die
7 years ago
so i got the IAC under a little better control. but now i am getting a real bad rich burn on it. the …In: stumbling and die
7 years ago
Is data log 45 from an idle? I am far from a pro with the data and the fitech units, but if thats at …In: Flooding
7 years ago
so how would I go about bringing the IAC steps up? I am still unsure on how all this works. but will …In: stumbling and die
7 years ago
so tonight I installed a FCC2 and tuned the fuel pressure down to 40-42 PSI running. the truck seems …In: stumbling and die
7 years ago
Yes still having issues. backfiring and studering then dieing when taking off from a stop and when a …In: stumbling and die
7 years ago
Ok. So I was just reading some stuff on the FCC2 and it is saying that for running the FCC on a syst …In: stumbling and die
7 years ago
Austin
I was reving the engine a little during that log. I have another log that is just idling. …In: stumbling and die
7 years ago
https://www.dropbox.com/s/dpvnljsp8w6tj56/DashBoard6.csv?dl=0
let me know if this worked.
than …In: stumbling and die
7 years ago
Austin
i am not up on computers and how to post/ share things so i did share a data log with you …In: stumbling and die
7 years ago
Ok got the software issue fixed. replaced the blue wire with a shielded wire and have it grounded at …In: stumbling and die
7 years ago
so i got the software to update everything seemed to go fine but now everything on the handheld is u …In: stumbling and die
7 years ago